Mobility of water molecules in Li+, Na+ and Cs+ ionic forms of Nafion membrane studied by NMR

Correlation times and diffusion coefficients of water molecules were measured for the first time by ¹H spin relaxation and pulsed field gradient NMR in Li⁺, Na⁺ and Cs⁺ ionic forms of Nafion 117 membrane. Hydration numbers of Li⁺, Na⁺ and Cs⁺ cations were calculated. It was shown that at high humidity macroscopic transfer is controlled by the local translational motion of water molecules.     

发动机机油滤清器虑层强度分析及优化

针对机油滤清器工作工况下进出口压差、机油滤层强度及导流桩高度等问题, 通过试验测试与仿真相结合, 对滤清器初步设计进行了评估及优化, 以确保滤清器在工作工况下进出口压降及滤层强度能满足要求. 首先进行滤层性能试验, 得到滤层的惯性阻力系数和黏性阻力系数; 再通过滤层多孔介质CFD分析, 对滤清器进出口压降进行分析计算. 结果表明: 在-18℃、25℃和70℃的工况下, 进出口压降都小于10kPa, 满足相关要求. 针对滤层的最大主应力超过其抗拉强度的问题, 通过CAE仿真分析, 优化滤层与导流桩间隙, 将滤层最大主应力由110.1MPa降至36.99MPa, 小于其抗拉强度42.8MPa.     

Design of diamond-shape photonic crystal fiber polarization filter based on surface plasma resonance effect

A novel plasmonic polarization filter based on the diamond-shape photonic crystal fiber(PCF) is proposed. The resonant coupling characteristics of the PCF polarization filter are investigated by the full-vector finite-element method. By optimizing the geometric parameters of the PCF, when the fiber length is 5 mm, the polarization filter has a bandwidth of 990 nm and an extinction ratio(ER) of lower than -20 dB. Moreover, a single wavelength polarization filter can also be achieved, along with an ER of -279.78 dB at wavelength 1.55 μm. It is believed that the proposed PCF polarization filter will be very useful in laser and optical communication systems.     

Theoretical studies on the influence of metallic cations on ring opening of propylene oxide catalyzed by metal-salen complexes

We studied the ring opening of propylene oxide (PO) by salen-M coordinated OH⁻ group [M = Al(III), Sc(III), Cr(III), Mn(III), Fe(III), Co(II), Co(III), Ni(II), Cu(II), Zn(II), Ru(III) and Rh(III)]. The results show that the ring-opening energy barriers for M(II) complexes are much lower than those with M(III) complexes in the gas phase, and the barriers correlate linearly with the negative charges on the OH⁻ group and the Fukui function condensed on the OH⁻ group. The nucleophilicity ordering in the gas phase can be rationalized by the ratio of formal positive charges/radius of M cations. Solvent effect greatly increases the barriers of M(II) complexes but slightly changes the results of M(III) ones, making the barriers similar. Analysis indicates that the reaction heats are linearly proportional to the reverse reaction barriers. The relationships established here can be used to estimate the ring-opening barriers and to screen epoxide ring-opening catalysts.     

稳定分层湍流中逆梯度输运的关联分析研究

本文采用关联分析方法研究了稳定温度分层湍流中的结构特性、输运特性，以及热量、动量逆梯度输运现象的尺度效应及其参数演化．首先采用大涡模拟方法对稳定分层湍流中的结构特性和输运特性进行了分析，将逆梯度输运发生的时间尺度作为已知条件，结合关联量分析方法在波数空间中的解析解，对逆梯度输运现象的尺度效应进行了分析研究．结果发现，稳定分层强度较大的流动中发生垂向热量及动量逆梯度输运现象，发生的结构尺度与关联分析所发现垂向热量、动量逆梯度输运的波数形成了呼应．随着分层强度增加，热量、动量的输运强度均受抑制，与逆梯度输运关联的流场结构尺度减小，同样的效应也发生在流场结构向下游演化的过程中．     

基于科赫曲线分形结构太赫兹带通滤波器

太赫兹滤波器是太赫兹通信、太赫兹成像和太赫兹检测等太赫兹应用系统中不可或缺的功能器件。按照不同的分类方式,滤波器有不同的种类,常见的按照选频功能可分为高通滤波器、低通滤波器、带阻滤波器和带通滤波器。为了实现在太赫兹波段的滤波效果,世界各地的研究人员利用不同的结构、材料和控制方式实现了功能各异的太赫兹滤波器,但是考虑到设计的器件要应用到太赫兹系统中,成本低廉、结构简单、性能优越的太赫兹滤波器一直是研究人员的追求。分形概念自提出以来在很多研究领域都有了快速发展,但是在太赫兹波段的应用还不是很常见,特别是应用于太赫兹功能器件的设计。引入分形中科赫曲线的概念设计并制备了一种新型的太赫兹带通滤波器,该滤波器是在金属薄膜上刻蚀出科赫曲线分形结构,当太赫兹波垂直入射到该滤波器时候实现了在太赫兹波段的窄带滤波。在滤波器的设计过程中,追求理论与实验相结合,首先在电磁仿真软件中建立科赫曲线分形结构滤波器模型进行计算,探究分形结构应用于太赫兹波段进行滤波的可行性,在进行多次计算之后得到优化后的尺寸和结构,然后根据优化后的尺寸加工出科赫曲线分形结构太赫兹滤波器样品,并且将样品放在太赫兹时域光谱系统中进行实验测量,得到实验数据后与仿真结果进行比较。在仿真中利用了时域有限差分法模拟科赫曲线分形结构太赫兹带通滤波器的传输特性,优化后的仿真结果表明:滤波器的谐振频率为0.715 THz,透射系数能够达到0.92,-3 dB带宽为21.9 GHz,将仿真得到的散射参数进行S参数反演得到了太赫兹滤波器样品的电磁参数,这在理论上分析了太赫兹波在谐振点处产生透射增强的原因。利用飞秒激光微加工系统制备了尺寸优化后的科赫曲线分形结构太赫兹带通滤波器样品,然后使用太赫兹时域光谱系统对样品的传输特性进行测试,对实验得到的时域数据进行快速傅里叶变换之后得到频域数据,再把频域数据进行归一化处理后与之前的电磁仿真结果进行对比,发现实验测得的结果与电磁软件仿真得到的结果较为吻合。     

The single-polarization filter composed of gold-coated photonic crystal fiber

A single-polarization filter comprising a gold-coated photonic crystal fiber based on surface plasmon resonance is designed and investigated. The pattern matching and coupled polarization characteristics analyzed by the full-vector finite element method (FEM) and losses at 1,540 nm are achieved to 1,016.01739 dB/cm (x-pol core mode) and 33.81917 dB/cm (y-pol core mode). The crosstalk (CT) value of the 1,540 nm band is ?853.12653 dB for fiber length $L=1,000\mathrm{\mu }\text{m}$ and the bandwidth is 850 nm. The working wavelength of the filter ranges from 1,280 nm to 1,540 nm by varying the diameter of outer air holes ($d_1$), the diameter of inner air holes ($d_4$), the metal film thickness (t), as well as the liquid refractive index (n).     

Enhancing signal-to-noise ratio and resolution in low-field NMR relaxation measurements using post-acquisition digital filters

The traditional way to enhance signal-to-noise ratio (SNR) of nuclear magnetic resonance (NMR) signals is to increase the number of scans. However, this procedure increases the measuring time that can be prohibitive for some applications. Therefore, we have tested the use of several post-acquisition digital filters to enhance SNR up to one order of magnitude in time domain NMR (TD-NMR) relaxation measurements. The procedures were studied using continuous wave free precession (CWFP-T₁) signals, acquired with very low flip angles that contain six times more noise than the Carr–Purcell–Meiboom–Gill (CPMG) signal of the same sample and experimental time. Linear (LI) and logarithmic (LO) data compression, low-pass infinity impulse response (LP), Savitzky–Golay (SG), and wavelet transform (WA) post-acquisition filters enhanced the SNR of the CWFP-T₁ signals by at least six times. The best filters were LO, SG, and WA that have high enhancement in SNR without significant distortions in the ILT relaxation distribution data. Therefore, it was demonstrated that these post-acquisition digital filters could be a useful way to denoise CWFP-T₁, as well as CPMG noisy signals, and consequently reducing the experimental time. It was also demonstrated that filtered CWFP-T₁ method has the potential to be a rapid and nondestructive method to measure fat content in beef and certainly in other meat samples.     

砂岩方梁断裂过程区范围的实验确定方法

裂纹前端的断裂过程区是引起岩石非线性断裂及尺寸效应的主要原因。利用数字图像相关技术对砂岩开展了三点弯曲梁实验,获得观测区域高精度的全场位移和应变数据,根据断裂韧带区域水平位移和水平应变的分布特征,结合裂尖岩石颗粒变化的微观分析,提出采用裂纹尖端水平位移波动性和水平应变突变性所得到的波动系数和水平应变突变值,确定断裂过程区形状和临界尺寸的方法。结果表明:砂岩断裂过程区的形状为不规则的狭长带状区域,断裂过程区的临界长度为11~13mm,临界宽度为1.58~2.36mm。断裂过程区区域内形变在趋向裂尖时呈指数增加,但其单位区域内的形变增量呈波动状态。该方法能够更加准确判断岩石断裂过程区的范围,有助于分析岩石的非线性断裂特性。     

Assessing the nucleophilic character of 2-amino-4-arylthiazoles through coupling with 4,6-dinitrobenzofuroxan: Experimental and theoretical approaches based on structure-reactivity relationships

A kinetic study of the reactions of potentially bioactive 2-amino-4-arylthiazoles with highly reactive 4,6-dinitrobenzofuroxan (DNBF) is reported herein in acetonitrile solution. The complexation reaction was followed by recording the UV–vis spectra with time at λ_max = 482 nm. Electronic effects of substituents influencing the rate of reaction have been studied using structure-reactivity relationships. It is shown that the Hammett plot relative to the reaction of DNBF with 2-amino-4-(4-chlorophenyl)thiazole exhibit positive deviation from the log k₁ versus σ correlation, while it showed excellent linear correlation in terms of Yukawa–Tsuno equation. It has be noticed that the nonlinear Hammett plot observed for 2-amino-4-(4-chlorophenyl) thiazole is not attributed to a change in rate-determining step but is due to nature of electronic effect of substituent caused by the resonance of stabilization of substrates. The second-order rate constant (k₁) relating to the bond C–C and C-N forming step of the complexation processes of DNBF with 4-substituted-aminothiazoles and 2-amino-5-methyl-4-phenylthiazole, respectively, is fit into the linear relationship log k = s_N (N + E), thereby permitting the assessment of the nucleophilicity parameter (N) of the 2-amino-4-arylthiazoles of the range (4.90 < N < 6.85). 2-amino-4-arylthiazoles is subsequently ranked by positioning its reactivity on the general nucleophilicity scale developed recently by Mayr and coworkers (2003) leading an interesting and a direct comparison over a large domain of π-, σ -, and n-nucleophiles. The global electrophilicity/nucleophilicity reactivity indexes of the 2-amino-4-arylthiazoles have been investigated by means of a density functional theory (DFT) method. .